Jumper the other IDE drive as Cable Select. If you are connecting your drive as the secondary drive on the cable with another IDE drive, there is no need to change the jumper pin on the drive. Installing the new drive as the secondary (slave) drive: Connect the drive to the black connector at the end of the cable for the system and the other IDE drive to the gray connector located at the middle of the cable. If you are connecting your drive as the primary drive on the cable with another IDE drive, there is no need to change the jumper pin on the drive. Installing the new drive as the primary (Master) drive: Simply connect the drive to the black connector at the end of the cable. If you are connecting your drive as the only IDE drive on the cable, then there is no need to change the jumper pin on the drive.
Installing the new drive as the only drive in the system: If you have determined that your system and all other IDE devices support Cable Select, please use the following information to connect your IDE drive. For Western Digtial 3.5″ EIDE hard drives:Ī) Cable Select Configuration Options for PC Systems: Both methods refer to having multiple devices attached to the same IDE cable and have options for single drive installations (only 1 drive installed on the system).ġ. You can use either of these protocols but you cannot mix them on the same data cable.
The end device is master while the device on the middle of the cable is slave. With this protocol, both devices are jumpered as cable select and their position on the cable dictates which device is the master and which device is the slave. With this protocol, one device is jumpered as master and the other is jumpered as slave. Two different protocols can be used for jumpering EIDE devices, including disk drives.
0 kommentar(er)
